MyCROCEMENT™ — The Premixed Microcement System
Professional-grade durability. DIY-friendly simplicity. A complete, ready-to-use system for seamless modern surfaces.
No Powders to Mix • 100% Waterproof Once Sealed • 2mm Ultra-Thin Finish
Shop KitsCalculate Your Coverage
Why Choose Premixed Microcement (MyCROCEMENT™)?
Traditional microcement requires precise liquid-to-powder ratios, high-shear mixers, and rapid application before it hardens in the bucket. MyCROCEMENT™ eliminates the guesswork entirely.
| Feature | Traditional Microcement | MyCROCEMENT™ (Premixed) |
| Preparation | Complex powder + polymer measuring | Zero mixing—open & apply |
| Consistency | Batch-to-batch color risk | Factory-perfect color & texture |
| Working Time | Fast-setting (high stress) | Forgiving, extended working time |
| Learning Curve | Professional experience required | Accessible for DIY & fast for Pros |
What’s Inside the System
1. Standard System
Ideal for low-traffic interior walls, backsplashes, and stable existing surfaces.
- MyPRIMER: High-tack primer that bonds to tile, drywall, wood, and laminate.
- MyCROCEMENT™ Finish Coat: Fully premixed, ultra-smooth decorative finish (zero mixing required).
- MyGUARD: Industrial-grade, waterproof, stain-resistant protective sealer.
2. Reinforced System
Recommended for Showers, Floors, Tile Overlays & High-Traffic Areas.
- MyPRIMER: Prepares and seals the substrate.
- MyBASE Paste (2-Component Base Coat): Mix MyBASE Powder with MyBOND liquid to create a flexible, high-strength structural base layer (applied in 2 coats).
- Fiberglass Mesh: Embedded directly into the 1st layer of MyBASE paste to bridge seams, grout lines, and prevent substrate cracking.
- MyCROCEMENT™ Finish Coat: Premixed decorative finish coat applied over the prepared base.
- MyGUARD: Waterproof, stain-resistant topcoat.
Step-by-Step Application Guide
Step 1: Prime
Roll on MyPRIMER to prepare and bond to the existing substrate
│
▼
Step 1A (Optional): Substrate Reinforcement (Reinforced System)
Mix MyBASE Powder + MyBOND liquid to form MyBASE paste
• Apply 1st coat of MyBASE paste
• Embed Fiberglass Mesh directly into the wet 1st coat
• Apply 2nd coat of MyBASE paste to encapsulate the mesh and level the surface
Lightly sand (80-120 grit) to smooth out any ridges and trowel marks
│
▼
Step 2: Finish Coat
Apply ready-to-use, premixed MyCROCEMENT™ finish coat for seamless texture
Lightly sand (80-120–220 grit) to smooth out any ridges and trowel marks and achieve desired texture after each layer, as needed to achieve the desired texture
│
▼
Step 3: Seal & Protect
Apply MyGUARD for a fully waterproof, stain-resistant barrier
The regular system (kit#1) has 3 application steps, the reinforced system (kit#2) has 4
CRITICAL TIMING & SITE CONDITIONS: Before starting, review our
Master Drying & Curing Guide
for mandatory environmental requirements and recoat windows.